Our Innovative Products

« Back to All Products

Sealer & Adhesive Remover

Categorized Under:

VanHearron's Sealer & Adhesive Remover is specifically built to 'break down" coatings as it chemically degrades adhesion properties. Formulated for long dwell time on more difficult jobs. Removes adhesive coatings, deep-set stain, grease, lacquers, waxes, varnishes and more. Just rinse clean with water. Powerful water base.

Interior / Exterior use.


Application Instructions


Surface Preparation: Read entire label before using. Provide good air ventilation to the room or area of application. Sweep or vacuum surface. Apply a liberal amount of Sealer and Adhesive Remover to a small, manageable area of up to 25 ft (2 M). Spread with a mop or brush. Allow product to dwell up to 1 hour without drying or until coating or residue softens. Do not allow Sealer and Adhesive Removerto dry on surface - if remover starts to dry, add more to ensure surface is kept wet. Agitate with a scrub brush or scrub machine. Wipe up residue with clean, absorbent white cotton towels. A wet/dry vacuum may be used. Removal of thick coatings or residue may require several applications - repeat steps 3 through 7 if coating is still on surface. Rinse thoroughly with clean water. Ready for surface traffic in 1 hour or after surface is dry to the touch. Allow at least 24-hour drying time before applying Sealer and Adhesive Remover.


CLEAN UP: Thoroughly rinse application equipment with water before material dries.



Wear skin and eye protection. If in eyes, flush with water for at least 15 minutes. If on skin, wash with soap and water. If irritation persists, seek medical attention. If swallowed, DO NOT induce vomiting, seek medical attention.

USE CHEMICAL-RESISTANT GLOVES, such as nitrile, when handling product.


Material Safety Data Sheet (MSDS)

Technical Data Sheet

© VanHearron, Inc.   :   All Rights Reserved   :   Sitemap   :   Privacy Policy   :   Website Designer