Our Innovative Products

« Back to All Products

Prep & Profile


Categorized Under:


Prep & Profile is "Shotblast in a Bottle!"

Bring soiled concrete back to life the easier way without man-handling equipment in unhealthy air.

Rids concrete of dirt and grime with the added benefit of leaving a 2-4 mil surface profile for a complete preparation for laying sealers, paints and coatings. A powerful water base that saves time and money.

 


Application Instructions


Read entire label before using.  Use only as directed.  Before applying, it is recommended that preliminary tests be carried out to determine usage and to test the effectiveness of the treatment.  Apply solution liberally on surface to be prepped with a low pressure garden style pump sprayer, or a plastic sprinkling can.  Use a stiff bristled brush (nylon deck brushes are suggested) to lightly spread product evenly over the surface, and allow solution to dwell for 5 minutes.  After 5 minutes, agitate the surface with the stiff bristled brush in a back and forth motion going north to south and then east to west to assure complete surface agitation.  Allow the agitated solution to dwell on the surface an additional 5-8 minutes and rinse thoroughly.  Allow surface to completely dry before analyzing results.  Repeat process as needed. DO NOT ALLOW SOLUTION TO DRY ON THE SURFACE! Repeat application process as needed to reach desired results.

Clean tools, equipment with fresh water. Water flush all primary surfaces, shrubbery, sidewalks, blacktop, asphalt, glass, equipment and all adjacent surfaces.

 

Limitations:

Do not allow solution to dry on the surface.

Do not use on polished marble.

Do not use on copper, brass or bronze.

Always test prior to use.


Precautions


For specific information regarding safe handling of this material refer to the Material Safety Data Sheet.


Downloads


Material Safety Data Sheet (MSDS)

Technical Data Sheet

© VanHearron, Inc.   :   All Rights Reserved   :   Sitemap   :   Privacy Policy   :   Website Designer