Our Innovative Products

« Back to All Products

Inhance Once and Done


Categorized Under:


Use on unsealed marble, granite, natural stone, unglazed tile, travertine, fabricated stone, and tumbled stone. Effective for interior and exterior applications. Works on most porous architectural substrates.


Application Instructions


  1. Read entire label before using.

  2. Test a small area according to application instructions with a 24-hour cure time to determine desired results. Test for stain repellency using likely contaminants. (Once enhanced, surface cannot be restored to original color appearance.)

  3. Surface must be clean, dry, and free of existing sealers or coatings.

  4. Apply using a sponge, paint pad, or cotton towel.

  5. NOTE: Be sure that any sealer that does not penetrate surface is polished dry off surface within 5 minutes of application using absorbent paper or cotton towels.

  6. If 2 or more coats are applied, allow a minimum of 30 minutes drying time between coats.

  7. Ready for surface traffic in 12 hours after final coat. Keep dry for 12 hours. Achieves full cure in 48 hours, some highly porous surfaces may require an additional coat after full cure.

  8. Clean applicator tools with mineral spirits after each use.


Precautions


Do not allow sealer to come in contact with any non-recommended surface as product is not completely removable. Sealers and finishes should not be used before or after use of Inhance Once And Done. If Inhance Once And Done is not WIPED COMPLETELY DRY within 5 minutes, a residue may form. If residue occurs, use a scrub brush with alcohol to remove. Keep floor surfaces dry and clean to reduce possibility of slip-fall accidents. Routine pressure washing will affect expected wear. Sealer will not prevent surface wear or washing from acids or caustic chemicals.


Additional Info


KEEP OUT OF REACH OF CHILDREN. Use in well-ventilated areas. Avoid prolonged skin contact. Rubber gloves and eye protection should be worn during application.

 

IF INGESTED: if person is conscious, immediately give 2 glasses of water and induce vomiting.   Seek medical attention.

 

EYE CONTACT: Flush with water. If irritation persists, seek medical attention.

 

SKIN CONTACT: Wash immediately with soap and water. If irritation persists seek medical attention.

 

INHALATION: Relocate to fresh air. If symptoms persist, seek medical attention.


Downloads


Material Safety Data Sheet (MSDS)

Technical Data Sheet

© VanHearron, Inc.   :   All Rights Reserved   :   Sitemap   :   Privacy Policy   :   Website Designer